Precautions before installation for magnetic powder clutch
Release Date:10/12/2015
1.the machine exposed rotating parts will hit and hurt human body possibly,it will be better to install a protective cover with ventilation to avoid accidents, it is recommended to use an equipment when protective cover was opened, the rotating part of the safety devices will be able to immediately stop.
2.when clutch/brake is working and sliding,the rotating internal components will be likely to be ignited by a little spark, so please do not use in grease and explosive atmosphere, and do not use near cloth,cotton and other flammable materials ,also,please consider sliding efficiency issue after separating .
3.Please do not install the equipment in dusty, hot, humid, cold, wind and rain place, and do not directly installed in a place where vibration or shock, or equipment damage, failure or performance deterioration.
4.When equipment rotates,please do not repair or touch, or they may cause an electric shock or injury,when installing, removing or debugging, please cut off the power and make sure that moving parts have stopped.
5.The bolts need to tighten when assembly, preferably with a higher progression bolts,in avoid of wounding because of bolt fracture,when lock bolts, it is better to use glue, spring washer or require a similar piece locking;In addition, because of relative rotation between rotating & fixing parts of clutch/brake,so the fastening assembly must be strong, to ensure safe operation of the machine.
6.The connection circuit and mechanical need to reliable and properly insulated,the wire size to load on must be set to meet the flow requirements, if wire ampacity is not enough, the insulating layer on the wire will melt and promoting insulation action,in this case, there may cause leakage, short circuit or fire.