Tension Controller Wiring Diagram Connection Method
Release Date:06/07/2019
Taiwan Tianji brand tension controller wiring diagram, connection method introduction, tension control system supporting instruments In addition to the tension controller, there are tension sensors, magnetic powder brakes, magnetic powder clutch and other important components.
Tension controller wiring notes:
1. Weak wires such as input signal lines, switch input and output terminals, and output power should be away from strong power lines such as instrument power lines and power supplies to avoid signal interference.
2. Note that the weak signal terminals such as input signal, switch input and output terminal, and output power supply must not be connected to strong power, otherwise the whole instrument will be burned.
3. Connect the tension sensor signal according to the correct wiring diagram. If you need to connect two tension sensors, you must pay attention to the signal polarity can not be connected incorrectly, otherwise the displayed measurement value will be inaccurate.
4. If only one tension sensor is connected, the input terminal without the tension signal must be shorted.
5. The tension sensor shield wire must be connected to the SG terminal.
The following is a fully automatic tension controller wiring diagram, schematic:
Selection, quotation.Order service hotline:15362446678 Sandra
Prev: Magnetic Powder Clutch Can Be Used On The Packaging Machine